Detail Structaset™ 401
Structaset™ 401
STRUCTASET™ 401 is a heavy duty Epoxy Acrylate adhesive for anchoring threaded studs and reinforcing bar into solid concrete, solid brick, stone, hollow brick and hollow concrete block. High bond strength for diamond and carbide drilled holes. Fast cure for high productivity. Non-drip formula, ideal for over-head installation. Styrene free. Steel columns, and beams, starter bars, road stitching, seating, hand rails.
FEATURES & BENEFITS
Easy dispensing even in cold weather
Carbide and diamond drilled holes – strong bond
Fast 50 minute ( at 20° C) cure for high productivity
Styrene Free
Approved for use in contact with drinking water ( AS4020)
ETA Approval
INSTALLATION GUIDE
Installation in Solid Concrete
1. Drill or core hole to specified diameter and depth
2. Remove dust and debris by brushing and blowing 3 times each ( if hole is wet or flooded, remove excess water using wet/ dry vacuum)
3. Screw mixing nozzle onto cartridge and dispense 2-3 trigger pulls of adhesive to waste until colour is grey with no streaks
4. Insert tip of nozzle to bottom of hole and dispense adhesive
5. Fill hole to about 2/ 3 full
6. Insert fixing with rotating motion to release trapped air
7. Wait until adhesive has fully cured before loading ( see Working Time / Loading Time chart below)
8. Clean up with Acetone
Tampilkan Lebih Banyak