Detail ChemSet™ Reo 502™
ChemSet™ Reo 502™
ChemSet™ Reo 502™ is an extra heavy duty adhesive for anchoring reinforcing bar and threaded studs into solid concrete, solid brick and stone.Two-component, high bond strength pure epoxy adhesive specially designed for structural connections, such as reinforcing bar. Suitable for dry, damp, wet and flooded holes. Quick setting for improved productivity. Long working time to reduce nozzle wastage. Suitable for oversized holes up 2 x bar diameter. Structural reinforcing bar connections in slabs, columns, beams and walls. Structural steel columns, raker angles, seating
FEATURES & BENEFITS
Quick 3 hour cure ( at 20° C) for improved productivity
Extra heavy duty bond
Sag resistant formula for horizontal holes
Bonds to carbide and diamond core drilled holes – strong bond
Oversized holes up to 2 x bar diameter
For Grade 500 reinforcing bar and Grade 8.8 anchor bolts
Excellent electrical insulation properties
Install in dry, damp, wet, flooded or underwater
Long 20 minute ( at 20° C) working time for deep holes and hot climates
INSTALLATION GUIDE
Installation in Solid Concrete
1. Drill or core hole to specified diameter and depth
2. Remove dust and debris by brushing and blowing 3 times each ( If hole is wet or flooded, brush only remove water and slurry with wet/ dry vacuum)
3. Screw mixing nozzle onto cartridge and dispense 2-3 trigger pulls of adhesive to waste until colour is light grey with no streaks
4. Insert tip of nozzle to bottom of hole and dispense adhesive
5. Fill hole to about 2/ 3 full
6. Insert threaded stud or reinforcing bar with rotating motion to release trapped air
7. Wait until adhesive has fully cured before loading ( see Working / Loading Time chart below)
8. Clean up with acetone
Tampilkan Lebih Banyak