Back to Top

Hi, Guest!

  LOKASI :  Bekasi (Harapan Indah)

Bergabung Selama :

BAGIKAN :   

Bagikan :
  • ChemSet™ 101 Plus

ChemSet™ 101 Plus

Update Terakhir
:
08 / 12 / 2019
Min. Pembelian
:
1 Unit
Dilihat Sebanyak
:
76 kali

Harga

CALL
Bagikan
:
JAYA TEKNIK adalah perusahaan yang bergerak dalam bidang peralatan bangunan, kontruksi, dan baja. Kami sebagai suplier alat-alat seperti Mesin bobok/ jack Hammer, mesin bor, alat gerinda untuk baja serta paku tembak/ ramset dengan merk HILTI. hubungi segera Heru : 0858 6846 2560 bisa cash on delivery agar terpercaya dan harga termurah

Perhatian !

Perusahaan ini terdaftar sebagai Free Member. Hindari melakukan pembayaran sebelum bertemu penjual atau melihat barang secara langsung. COD (Cash On Delivery) atau bertemu langsung dengan penjual merupakan metode transaksi aman yang kami sarankan.

Detail ChemSet™ 101 Plus

ChemSet™ 101 Plus Fast cure, medium duty anchoring of threaded studs and reinforcing bar into solid concrete, stone, hollow brick and hollow concrete block. Styrene free. Versatile, multi-purpose two part polyester anchoring system. Fast cure and fast dispensing for high productivity. Non-drip formula, ideal for overhead installation. Steel columns and beams, seating, machinery, facade pins, handrails, gates, starter bars, bottom plate fixing FEATURES & BENEFITS Easy dispensing, even in cold weather Fast curing for high productivity Sag resistant formula for horizontal holes and overhead applications Tap Valve to preserve contents between uses Solid concrete, hollow brick and concrete block VOC Compliant and Styrene Free INSTALLATION GUIDE Installation in Solid Concrete 1. Drill hole to specified diameter and depth 2. Remove dust and debris by brushing and blowing 3 times each ( If hole is wet or flooded, remove excess water with wet/ dry vacuum) 3. Screw mixing nozzle onto cartridge and dispense 2-3 trigger pulls of adhesive to waste until colour is green / grey with no streaks 4. Insert tip of nozzle to bottom of hole and dispense adhesive 5. Fill hole to about 2/ 3 full 6. Insert threaded stud or reinforcing bar with rotating motion to release trapped air 7. Wait until adhesive has fully cured before loading ( see Working / Loading Time chart below) 8. Clean up with acetone
Tampilkan Lebih Banyak